• AMP-200
  • AMP-200

AMP-200

2 CHANNEL HIGH CURRENT

A team OSD favorite, the AMP200 is a high current 2-channel amp with loads of features. This amp lets you home run (directly to the back of the amp) two pairs of speakers or 4 speakers total. Since it's high current, you can add up to 4 pairs of speakers (8 speakers total) by adding OSD speakers selectors such as the DSM4. Rated at 80 Watts per channel at 8 ohms, the OSD-AMP200 is overload stable so it’s ideal for use anywhere clean power is needed. It also includes a dual source switching circuit. When you connect two independent sources number (say your iPod and a TV in another room) source one takes priority when it is active. When source one is turned off, source number two comes on. Note: You cannot play two sources simultaneously. For this feature you need a multi-channel amp like our MX1260. Step-up features rarely seen in amps of this price range include a built-in voltage meter, and front mounted volume and balance trim controls.
AMP-200

Specs

  • Two sets of speaker outputs selectable from the front panel
  • 2 stereo low-level (RCA) inputs and 1 high-level (speaker) input
  • 80W per CH into 8 ohm loads with less than 0.2% THD+N
  • 125W per CH into 4 ohm loads with less than 0.2% THD+N
  • 200W per CH into 2 ohm loads with less than 0.2%THD+N
  • 250W Bridged Mono into 8 ohms with less than 0.2% THD+N
  • Crosstalk: >65dB @ 1kHz, ref. to rated power into 8 ohms
  • Frequency Response: (20Hz to 20kHz)+0.0dB, -0.5dB
  • Signal to Noise ratio: -103dB ref. to rated power into 4 ohms
  • AC Power Consumption: 700W (all channels driven)
  • Dual Voltage 110/220V
  • Front-panel power switch
  • 12-volt trigger
  • Auto-signal sensing function
  • <1W Standby Power Consumption

Downloads